Skip to main content

Trading Partner Onboarding - Home Hardware

If you are looking to implement Home Hardware as a new Trading Partner within your EDI network, this article will provide you with an understanding of the requirements, preliminary and next steps, as well as commonly used transaction types.

S
Written by Stacie McGee

Trading Partner: Home Hardware


EDI IDs


Home Hardware utilizes the following Electronic Data Interchange (EDI) IDs for identification purposes. These EDI IDs are made up of a Qualifier and an ID which will be sent within their Interchange Control Header, ISA segment, on your inbound transactions. This allows Transaction Manager to be able to identify the Sender and Receiver of any sent/received EDI transaction.

The table, below, lists the most common EDI IDs used by Home Hardware.

X12 Qualifier

EDI ID

Primary ID?

01

201481793

Yes

01

RVL201481793

No

Home Hardware will expect a specific EDI ID based on your business relationship with them. Selecting the wrong EDI ID will result in EDI Transactions not being sent or received.

You will need to work with Home Hardware to determine the proper EDI ID to use.


Preliminary Steps


To initiate the EDI Setup, Home Hardware's EDI Coordinator must be contacted directly at [email protected]. The Home Hardware New Trading Partner Form must be completed and sent to Home Hardware.


Direct Trading Partner Testing


Home Hardware requires you to complete compliance testing before Go-Live. Refer to the Next Steps section in this article for detailed instructions and expectations. If you prefer, TrueCommerce can conduct and complete compliance testing on your behalf.


Commonly Used Transactions


The table, below, lists the most commonly used EDI transactions with Home Hardware:


Next Steps


Once the purchase of the Home Hardware plug-in is complete, your Implementation Specialist will reach out to schedule time to complete and/or coordinate a plan for compliance testing and/or Enterprise Resource Planning (ERP) system integration testing.


Related Documentation


rev: 8/12/2026


Did this answer your question?